Vanner RE Series Instalační manuál stáhnout pdf (Strana 33)

RE Installation Manual

3-28



2001 Phone: (614) 771-2718 RE-4500

Vanner Inc. FAX: 614-771-4904 Owners Manual

4282 Reynolds Dr. www.vanner.com Rev 01e

Hilliard Ohio 43026 RE-Installation_Manual_Rev01e 910157-A

INCORPORATED

INCORPORATEDINCORPORATED

INCORPORATED

Warning

It is important to disconnect ALL AC sources to avoid electric

shock!

AC Voltage is extremely dangerous and contact with AC Currents

can lead to injury, damage to property, and death!

Use the AC disconnect to insure that ALL potentials are disabled.

Use a lockout to insure that voltages are not inadvertently

reconnected.

Note

It should be noted that the RE-4500 does not require the rewiring

of Multiwire branch circuits since it is a true 3 wire 240 Vrms

output.

The wiring of your inverter installation should conform to

the National Electric Code (NEC) and any other state or

local codes in effect at the time of installation. These codes

have been written for your protection and their

requirements should be followed.

Remove the bottom cover (for the AC Raceway) to expose

the AC wiring compartment and the AC Utility and Load

Wiring Terminal Block. Input and Output Circuits for L1

and L2 are identified on the terminal block label and are

defined in Figure 3-10.

Route the AC output wiring with as much physical

separation as possible from low voltage wiring such as

audio and video signal wires, and the Input DC wiring.

This is accommodated in the system through the physical

separation of the AC and DC wiring raceways.

Verify that the AC utility cables are still disconnected from

the AC Utility (or Vanner ACM).

Insert AC utility cables through the knockout and into the

AC wiring raceway.

Connect L1, N, L2 and ground to the appropriate terminals

in the terminal strip and torque each of the AC terminal

screws to 15 inch pounds. Re-torque after 30 days.

Verify that the AC output cables are still disconnected

from the AC load (or Vanner ACM).

Insert AC utility cables through the knockout and into the

AC wiring raceway.

1 2 ... 28 29 30 31 32 33 34 35 36 37 38 ... 91 92

Komentáře k této Příručce

Žádné komentáře

Vanner RE Series Instalační manuál Strana 33

Komentáře k této Příručce

Související produkty a manuály pro Napájecí adaptéry a střídače Vanner RE Series