Vanner RE Series Instalační manuál stáhnout pdf (Strana 29)

RE Installation Manual

3-24



2001 Phone: (614) 771-2718 RE-4500

Vanner Inc. FAX: 614-771-4904 Owners Manual

4282 Reynolds Dr. www.vanner.com Rev 01e

Hilliard Ohio 43026 RE-Installation_Manual_Rev01e 910157-A

INCORPORATED

INCORPORATEDINCORPORATED

INCORPORATED

Insert the DC cables through the appropriate knockout and

into the DC wiring raceway.

Torque the DC cable mounting bolts to 105 inch pounds.

Re-torque after 30 days.

Inspect the DC cable compartment to be sure no copper

wire fragments are present after tightening cables.

Route the negative DC cable to the DC source disconnect

(or Vanner DCM). Verify cable polarity before proceeding.

Warning

If the cables are reversed, the fuse will be blown and inverter can

be damaged.

10.

Route the positive DC input cable to the DC disconnect.

Protect cables with loom and use grommets or other

appropriate means where cables may contact hard, sharp

edges. If possible, make the last DC connection at the

disconnect to avoid causing a spark at the battery.

11.

If any of the control NC or NO outputs need to be wired,

for control of external devices, do so at this time.

12.

Route the control NC or NO wiring with as much physical

separation as possible from low voltage wiring such as

audio and video signal wires, the Input DC wiring, and AC

wiring. This is accommodated in the system through the

physical separation of the High Current DC knockouts and

the Control knockouts for the DC Raceway.

13.

Verify that the control NC or NO wiring is still

disconnected from the device to which they are to be

attached.

14.

Insert control NC or NO wiring through the knockout and

into the DC wiring raceway.

15.

Connect the NO, NC, Common, and +24VDC and GND to

the appropriate terminals in the terminal strip and torque

each of the AC terminal screws to 4 inch pounds. Re-

torque after 30 days.

16.

Verify DC wiring installation. Verify that all connections

are tight. Secure all wiring and replace the DC Raceway

cover.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 91 92

Komentáře k této Příručce

Žádné komentáře

Vanner RE Series Instalační manuál Strana 29

Komentáře k této Příručce

Související produkty a manuály pro Napájecí adaptéry a střídače Vanner RE Series